Satellite finder can receive the signal but the digital machine shows no signal how to solve?

2017-05-25

Satellite/Terrestial Receiver

Satellite finder can receive the signal but the digital machine shows no signal how to solve?


When using the satellite finder, the satellite finder may receive a signal but the digital display shows no signal. The following are the possible reasons and the solution.


Reason:

1. Not the satellite signal that the user wants to find.

2. High frequency head polarized. Focal length placed incorrectly.

3. The signal is weak

4.Satellite finder pointer refers to the largest, but no signal.

5. In the absence of adjustment of the antenna, the pointer is always pointing at the maximum.


Solution:


1. Adjust the satellite and re-receive the signal.

2. Adjust the satellite placement

3. Through the reducer and then adjust the pointer between 4-5, re-adjust the antenna or tuner, so that the signal has increased again.

4. Because the satellite finder received the signal only to determine whether the antenna direction of the existence of a satellite, rather than the required signal directly on the satellite finder dial, it is only looking for a satellite signal auxiliary equipment.

5. Check that the front of the antenna is blocked against the building or the front. If none of these phenomena exist, it indicates that the LNB gain at this time is too large and is lost to the satellite finder.


The above is the solution to the satellite finder problem, learn more about the satellite finder content, please pay attention to kepnixshop official website.


Back
Newsletter